You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3
  1. 06-17-2008 09:36 AM #1
    gphillipsjr
    gphillipsjr is offline Member
    Join Date
    Jun 2008
    Location
    Massachusetts
    Posts
    18

    Default 5lb tank and Coors Light Keg

    Will both the 5lb tank and the keg fit in the Nostalgia kegerator? I have to swap out my 2.5lb for a 5lb today and want to make sure it will fit with the CL keg.
    Reply With Quote Reply With Quote  
  2. 06-17-2008 12:42 PM #2
    jumper
    jumper is offline Senior Member
    Join Date
    Feb 2008
    Posts
    243

    Default

    I remember someone else saying they couldn't fit them both in there. I'm still using the 2.5 lb tank that came with mine but the 5 lb tank increases the dia. by over an inch, I think it'll hit the chimes and you won't be able to get the door closed.
    Always do sober what you said you'd do drunk. That will teach you to keep your mouth shut.

    Ernest Hemingway
    Reply With Quote Reply With Quote  
  3. 06-17-2008 03:51 PM #3
    gphillipsjr
    gphillipsjr is offline Member
    Join Date
    Jun 2008
    Location
    Massachusetts
    Posts
    18

    Default absolutely right

    it does not fit at all. Any ideas on how to drill into this thing to mount the bottle on the back? It also looks like the gas line is not going to be long enough. Is there a way to splice that or do I have to get a new one?

    Update: I got a new line to run the co2 on the outside of the unit just not sure if I can mount it anywhere, and not sure where to drill.
    Last edited by gphillipsjr; 06-17-2008 at 07:55 PM.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.