You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3
  1. 11-24-2005 06:51 PM #1
    ryansears
    ryansears is offline Junior Member
    Join Date
    Nov 2005
    Location
    , , .
    Posts
    2

    Default Haeir Disassembly question??

    hey everyone....

    heres my question. I have a nice wood bar in my house and i am getting the Haier Kegerator tomorrow. What i would like to know is if it is possible to disassemble the kegerator and run the hoses through a hole i want to drill in my bar so that the Faucet is on the top of the bar. Is is this possible or do i have to keep it assembled next to my bar?

    thanks

    -ryan
    Reply With Quote Reply With Quote  
  2. 11-25-2005 05:26 AM #2
    topgun3208
    topgun3208 is offline Senior Member
    Join Date
    Apr 2005
    Location
    maryland
    Posts
    424

    Default

    Hey Ryan, welcome to the forum. Scott from micromatic can get you squared away on your ?. A few people in here have had issues with the Haier t'stat (getting the temp. low enough). I would check that before any disassembly!
    Reply With Quote Reply With Quote  
  3. 11-27-2005 05:06 PM #3
    BigStein
    BigStein is offline Senior Member
    Join Date
    May 2005
    Location
    , , USA.
    Posts
    69

    Default

    You may already have this all squared away but if you don't: The Haier does not come pre-assembled so you will need to put the tower and faucet together anyway. So you can certainly put the faucet on top of the bar if you would like. If you have issues with the temp. (as I, and many others, did) then follow these instructions for the solution:

    http://www.tommydehart.com/fun/keg/haier_brewmaster.htm
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.