Home

Find Local System Installers Find Local Beer Line Cleaner Buy Beer Equipment

Toll Free Orders: 1 (866) 291-5756

Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Kegerators & Kegerator Kits @ Home
1/4" I.D. beer line

Mark Forums Read

Reply

#1 (permalink)

Old

02-20-2008, 10:37 AM

indianaroller indianaroller is offline

indianaroller is offline

Senior Member

Join Date: Feb 2007

Posts: 53

Default

1/4" I.D. beer line

How long of 1/4" beer line should I use. I'm hooking up a soda keg and the barb is 1/4".

Reply With Quote

#2 (permalink)

Old

02-20-2008, 03:20 PM

psychodad

psychodad is offline

Super Moderator

Join Date: Feb 2006

Location: , , USA.

Posts: 1,167

Default

The length is going to depend on other variables such as type of beer, temperature co2 pressure, etc. If this is an existing setup, you will find that the 3/16 line you likely have will easily go on the 1/4 barb for your corny.

__________________
Malt is the soul of beer... and yeast gives it life..
but the kiss of the hop is the vitality of that life!

My three favorite beers: The one I just had, the one I'm drinking now and the next one I'll have.

Reply With Quote

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

All times are GMT -7. The time now is 07:19 PM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.