Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 01-21-2008, 03:22 PM
wildwest450 wildwest450 is offline
Member
  
Join Date: Nov 2007
Location: Sparta, TN.
Posts: 17
Default help a fool out...
trying to find a male end with 3/16 barb to fit this http://www.micromatic.com/draft-keg-...s-pid-874.html this will be the last piece I need to go from sanke to corny. My homebrew will be ready in 10 days, so I need help! It would look something like this
Last edited by wildwest450; 01-21-2008 at 03:37 PM.
Reply With Quote
  #2 (permalink)  
Old 01-21-2008, 04:04 PM
psychodad psychodad is online now
Moderator
  
Join Date: Feb 2006
Location: , , USA.
Posts: 729
Send a message via Yahoo to psychodad
Default
3/16 brass tailpiece. http://www.micromatic.com/draft-keg-...-pid-526A.html

But I can't see that helping you go from sanke to corny.
__________________
Malt is the soul of beer... and yeast gives it life..
but the kiss of the hop is the vitality of that life!
Reply With Quote
  #3 (permalink)  
Old 01-21-2008, 05:04 PM
wildwest450 wildwest450 is offline
Member
  
Join Date: Nov 2007
Location: Sparta, TN.
Posts: 17
Default
Quote:
Originally Posted by psychodad View Post
3/16 brass tailpiece. http://www.micromatic.com/draft-keg-...-pid-526A.html

But I can't see that helping you go from sanke to corny.
Im tyring to make a short jumper from the corny keg so I can just unscrew the beer line and screw it into this mystery fitting.
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 10:44 PM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.