Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Kegerators & Kegerator Kits @ Home
CO2 line pressure

LinkBack

Thread Tools

Display Modes

#1 (permalink)

09-20-2007, 05:18 PM

Scheff

Member

Join Date: Sep 2007

Posts: 6

CO2 line pressure

I bought a new regulator for my kegerator and the original co2 line did not fit onto the new regulator. I went out and bought two barbs, one male and one female, to fit together and make a bridge between the two different size hoses. So far the fitting holds and there are no leaks of CO2. When pouring the beer I have been getting almost entirely foam and I was wondering if this might be a result of having two different size hoses? Anyone have any thoughts on why this might be happening?

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

All times are GMT -7. The time now is 07:55 PM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.