You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3
  1. 07-26-2007 09:47 AM #1
    Dr J
    Dr J is offline Member
    Join Date
    Jul 2007
    Location
    NJ
    Posts
    7

    Default ? About undercounter Kegerator

    Just purchased an Undercounter Kegerator:

    Dual purpose space-saving kegerator. Designed to be built into cabinet or freestanding.
    Front ventilating compressor draws cooling air from front. Eliminates need for clearance space for air circulation around the back or sides of the unit.

    The Question: Can the cabinet door be closed or does it need to be open?

    I have a 4 inch space in between kegerator and a closed cabinet door. The cabinet door has two small vents in it. The wall behind the kegerator has a vent to the outside of the house as well as a vent on the side wall to the inside of the house.

    Thanks.
    Reply With Quote Reply With Quote  
  2. 07-28-2007 09:11 AM #2
    thehammer
    thehammer is offline Member
    Join Date
    Apr 2006
    Location
    MI, USA.
    Posts
    30

    Default

    Sounds good to me to close the door. However, I would try calling the manufacturer of the kegerator. I have a True and the people there were really helpful when it came to drilling a few holes for gas lines into mine. A number should be listed in your owner's manual.
    When in doubt just get hammered!
    Reply With Quote Reply With Quote  
  3. 07-31-2007 04:12 PM #3
    Dr J
    Dr J is offline Member
    Join Date
    Jul 2007
    Location
    NJ
    Posts
    7

    Default

    Thank you. I'll do that.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.