Adding a 90 degree elbow

[chuckster_ca]

Just wondering if it's possible to add a 90 degree elbow to my keg coupler after the keg has been tapped. If so, how do I go about doing that?

Thanks

[edramshaw]

You would just untap the keg. Turn off the gas. Engage the coupler to release on gas in the line. Pull off the beer jumper. Add 90 degree elbow and retap.

[chuckster_ca]

Thanks for the quick response..

[Scott Zuhse]

Uncouple keg, remove hex nut from top of coupler and replace with this elbow and beer washer. Place Then place the earlier removed hex nut onto the elbow using beer washer. Recouple keg.