Quote:
Originally Posted by cubby_swans
1)Your sensor is behind the grill plate on the LEFT lower wall of the inside of the unit, as you are looking into the unit. It just pries off. The sensor wire only stretches out about 6 - 8 inches, so I just pulled mine as far to the front as it would go, and electrical taped it to the wall in one of the railing recesses, so I didn't break it when putting in a keg.
2)you can unplug the sensor wire. You'll see where once you've completed step one. I was able to insert each side of the resistor into the female end of the plug, and then plug back in the sensor. That way you've got the resistor installed with no soldering. Othersise just seperate the two wires coming from the sensor, and solder one resistor lead to each of the wires. Basically bridging them.
|
Thanks again!
1) Can I extent the sensor wire by soldering something longer? 6" to 8" won't take it that far forward or higher, which seems to be my main focus.
2) So in 1 and 2, I'm modding the same wire? Moving it up/forward in step 1, and putting the resistor in during step 2? Or will this make a whole lot more sense once I open up the grill plate?