Hi all,
I'm planning on picking up the danby and performing the mods mentioned in this forum.
I plan to locate the kegerator itself in a backroom, and run the beer line through a shared wall with the pool room on the other side. The tap will be installed in the backsplash of the bar. The total beer line length will be less than 5'. I plan on cooling the beer line and shank with a blower (as so beautifully laid out in this forum!)
What size nipple shank assembly do I need with the DKC645BLS? I see two types on micromatic:
3/16" Bore:
http://www.micromatic.com/draft-keg-...-4331NA-3.html
1/4" Bore:
http://www.micromatic.com/draft-keg-...id-4331NA.html
Does anyone know the inner diameter of the DKC645BLS beer line?
Thanks!
Scott