Home made tower
Another newb here. Just now putting together a home dispensing system with a small chest freezer.
Another homebrewer on another list made a dandy 2-faucet tower from 3-inch PVC pipe. I'm making the same basic design. Problem is most homebrew supply sites don't have shanks any shorter than 3 inches. That's obviously too large to fit inside the tower. On the Micromatic site, there is a photo of an elbow shank that seems like it should work. Anyone familiar with this or with anything else that might work?
Also, most shanks have a flat collar instead of one that will conform to the rounded outside surface of the tower. Any thoughts on solving this?
Thanks!
|