I apologize in advance for the number of questions.
I recently acquired a used Beverage-Air tapster/kegerator. It seems to be a BM23, though the model may actually be somewhat older (it says Superior Products outside but has the Bev-Air label inside). The set up seems exactly like the BM23. It currently has a 2 1/2" single faucet chrome tower which I was wanting to replace with a 3" dual faucet tower. Obviously new pilot holes for the tower will need to be drilled but I was wanting to make sure all the issues and items I needed were accounted for. I was planning on ordering:
3" dual faucet tower
http://www.micromatic.com/product.php?pid=D4743DT
Two new keg couplers (D)
http://www.micromatic.com/product.php?pid=7485E-R
http://www.micromatic.com/product.php?pid=7485E-G
Double gauge 2 outlet regulator
http://www.micromatic.com/product.php?pid=842-2
2 X 5' gas hose
http://www.micromatic.com/product.php?pid=553R
4 x worm clamps for gas line
http://www.micromatic.com/product.php?pid=705W
Cool air line
http://www.micromatic.com/product.php?pid=1651
2qt. Cleaning kit
http://www.micromatic.com/product.php?pid=CK-1200
Is there anything I'm missing?
Is the 3" tower insulated?
There was another 3" tower (D4743DS) listed with "bent beer assembly" what's the difference/benefit of that?
The current tower has the air line hooked to the faucet assembly, I assume I'd do the same again with the larger tower.
Is the air line hose I've selected correct?
Does the tower come with or need a gasket?
It looks like the connectors on the cleaning kit hook up to the hex nut on the beer line, is that right?
I assume if I want to change keg connectors they just hex nut on or off?
Are there any beer or gas line washers needed with the above?
Thanks for much for your time.