okay, I think have the tower assembly bit down. Thanks for the write-up chadschloss78. I do have a couple questions though. What did you make your rubber gasket out of? Is it just a square rubber piece that you cut out?
Also, I'm going to be running flexible aluminum air ducting from the blower to the new 3" hole to the tower. What would be the best method for attaching that to the hole, and allowing air to be able to flow back out. The smallest diameter ducting I can get is 3 inch. On the inside, how are you you attaching the duct to the electrical socket you retro-fitted. How do you keep it from sliding up or down?
And finally, how is the blower to be connected to the power supply. My Danby has the controller on the back of the unit by the drip tray. I am not currently using any after-market temp control so the danby still controls it's own compressor.
Last edited by Filch; 06-04-2007 at 01:19 PM.
|