I have a Danby kegerator which has been having the same temp problems as the other Danby owners seem to have had. I've been reading over the different ways people have fixed the problem and I have a quick question. I was considering adding a 33K ohm resistor to the temp sensor as lunkhead did
Danby Kegerator Improvements
I just wanted to double check how exactly to hook the resistor up before I begin. I've attached a picture of how I believe it should be wired.
Also should I wire the resistor to the lead that comes out from the side of the kegerator or to the section that is right next to the sensor?
Thanks in advance for the assistance.