I just looked over the whole beer line, the end that connects to the sanky is a ******* end and i can't take it apart...best I can tell it looks fine though. The end that connects to the faucet (there is no shank going down the tower) is also fine. I took it apart and didn't feel any burs or sharp edges. The flow rate sounds about right. There are no kinks in the beer line, and the twists are gradual and only because of the slack in the line. The sanky is a 1/4 turn with a lever to engage the probe. as for the probe itself, with it extended I didn't notice anything that screwed on, if it does then it seems tight, also looked over the gaskets again and there is nothing wrong with them. I could only find one vent hole in my faucet which is in the front of the faucet above the spout, but below the handle (hopefully that makes sense, I can take a pic and attach the file if it would help) and that looks clear. As for whether I get foam all the time, or only for the first pour or 2, that's an excellent question. I just poured 4 beers in a row to find out, and it only foamed the first 2 times The second 2 had the perfect amount of head. What would cause that?
Mike
|