Hope your using a blender:
5' 3/16" 15 lbs. restriction
6' lift 3 lbs. restriction
80' run (5/16" trunkline)8lbs. restricion (3/8" trunkline)4.80 lbs. restriction
1 lb. hardware
Total 5/16" trunkline = 26lbs.(4 lbs. high even with a blender) 3/8" trunkline =22.8 lbs bearable with a blender 60%CO2/40%N2
Did you make sure all product lines were touching glycol lines when making connections? Did you wrap all connections with moisture barrier tape and foil tape?
Micro Matic Blenders and Trumix Blenders will shut down when primary pressure goes below 50 lbs. from the primary regulators on either the CO2 or the N2 tank, so you should know right away if low pressure at the tanks is your issue.
Your temp at the faucet tells you your pump is working, 80 ft run and your faucet temp, pumps working
fine
|