ok i figured it out with the help of my friendly local neighborhood homebrew specialist.... i told ya i was new at this.. lol
Step 1. install keg in kegerator.
step 2. close co2 tank valve on regulator.
step 3. tap keg
step 4. Pull Blow off ring on keg tap assembly. might have to do this a few times
step 5. adjust pressure for keg (Fat Tire - approximately 5-8 PSI)
Step 6. open co2 valve on regulator.
Step 7. Test pour into a pint glass
step 8. if all goes well, drink test pour.
Head of beer should be aproximately the size of a nickel tall.
|