Another foaming question from a new owner.
I recently purchased a Danby chill n tap from my local sams club. Everything is installed per the booklet, CO2 set at 11 psi into the keg but it is pouring almost nothing but foam. I know that I didnt let the keg sit for long enough after I transported it, so I let it sit (tapped) overnight.
I called danby and they had me set the CO2 lower (about 6 psi) and did some other tests. They are sending me a new spout in the mail, should be here in 4 days.
1.) The beer in the lines has very little foam. Only one section I found with less than a half inch of foam. The rest of the line is clear beer. Danby said this is normal.
2.) Pressure now set to 6 psi as stated and turning off the CO2 to the keg makes no difference.
I suppose I am waiting 4 days for the new spout to arrive, but if anyone has any suggestions they would be appreciated.
|