[NoodlesWIU]

Here's my question before installing the Brewers Edge II on my new Danby and cutting the wires to the Danby Controller. If I cut the wires as directed in other posts and splice them so the control of the compressor is given to the brewers edge, and then I plug the Danby cord into the female plug of the Brewers edge, wont this shut off the power to the whole unit including the Blue LED on the front of the Danby when the brewers edge reaches its set temp???

I like seeing the LED easily with a reading of the unit's temp without having to look at the back of the unit to check the Brewers Edge II display, which so far I think the Danby LED is pretty accurate, I just want a 1 to 2 degree cycle of the compressor to keep my beer at about 34 - 35 degrees. Instead of the their range of around 4 - 5 degrees I think the Danby is set to cycle the compressor at.