Thats whats driving me nuts...
I am not using the worm clamps but will try. I know it is not the regulator because it holds the high pressure, based on the recommended test on this site.
The ONLY time it loses HIGH Pressure is when the keg is coupled, the main valve is off and the secondary valve is open. This leaves only the
Keg seal
Coupler
Beer Line
I know it is not the keg because I switched out kegs and I am having the same problem.
I just got a new coupler under warranty from Danby. I guess it could be likely that they sent me another bad coupler???
This leaves only the beer line...
I put the washer in as suggested...still losing High Pressure.
Is there somewhere else on the beer line it could be leaking CO2 without leaking Beer?
How tight should the beer line connection be at the coupler?