Use two
120' coils under each tower location(place in an insulated cooler - Rubbermaid or Gott water dispenser???) and mount them as best you can to the underside of the table. Mount the
towers over these containers with a 3" inch hole in top of table.
To be successful, fill the towers with ice and keep them filled during the event. You may need to use a tube bender to bend the 1/4" OD stainless to make connection to shank in tower.
Use one keg centered under the table (hopefully it fits) using an
898B "Y"fitting on top of keg coupler. Connect two 3/8" ID vinyl lines from this fitting to the coils. Use this
shank to connect the two.
Push with 32 to 36 PSIG. Do not put ice on coils until beer you run beer through system.